Skip to content
Back to Blog
Office Moves & Workplace

Office Acoustic Comfort: A Noise Management Guide

May 12, 2026
MAFM Team
7 min read
Office Acoustic Comfort: A Noise Management Guide

Acoustic comfort in an office means people can concentrate when they need to, talk when they need to and keep private conversations private. In open-plan offices that balance is hard, and noise, especially overheard speech, is one of the most consistent complaints facility managers hear.

The fixes are mostly cheap and operational: keep the HVAC background sound in range, put absorption where voices reflect, separate noisy spaces from quiet ones and set clear norms for calls. Sound masking is one tool among several, not a cure by itself.

Why is noise such a persistent office complaint?

Because overheard speech is distracting and open layouts spread it. The General Services Administration's workplace guide, Sound Matters, reports that in seven federal offices redesigned to be more open, satisfaction improved in almost every environmental factor except noise and voice privacy, which stayed lower than satisfaction with temperature. GSA also says the biggest source of disruptive noise is conversation, not machines.

Independent research points the same way. An analysis of the Center for the Built Environment's occupant survey database found enclosed private offices ahead of open-plan layouts on most comfort measures, and sound privacy was the most unsatisfactory factor of all. Roughly half or more of open-plan occupants were dissatisfied with it, between 49% and 59% depending on partition height (Kim and de Dear, Journal of Environmental Psychology, 2013). The same study found that easier interaction between colleagues did not offset the penalty of noise and lost privacy.

Interruptions cost more than annoyance. GSA notes that distractions shift attention, raise the effort needed to concentrate and can force a worker to re-orient, which it says can take up to 15 minutes, and that complex tasks suffer most.

This post does not repeat the widely quoted claim that noise cuts productivity by a fixed percentage. The sources above support the direction of the effect, not a single number.

How do you diagnose where the noise comes from?

Walk the floor at the busiest and the quietest times and write down what you hear. The Whole Building Design Guide groups office noise problems into three: noise entering from outside, noise from adjacent spaces and a lack of sound control within the space. It adds that office noise is typically not loud enough to harm hearing; the harm is that it distracts from concentration.

A useful survey of a floor looks at four things:

  • HVAC sound: a constant hiss, rumble or tone at desks.
  • Speech paths: where voices travel, usually from conference room doors, break areas, printers and circulation routes.
  • Hard surfaces: glass, bare ceilings and hard floors that bounce sound around.
  • Leaks between rooms: gaps at doors, ceiling plenums and ductwork.

On that last point, GSA's guide is blunt: a closed door does not make a room private unless construction has stopped sound leaking "around doors, through walls, through the ceiling plenum, through ducting." It compares sound leaks to water leaks: a building manager would act on the second right away, but we are expected to dismiss the first.

What HVAC sound level should you aim for?

The WBDG gives typical background-sound targets by room type, using Noise Criteria (NC) ratings: NC 35 to 40 for general offices, and NC 30 to 35 for small private offices, small conference rooms and libraries (WBDG, Acoustic Comfort). It also warns about both extremes: if the system is too noisy conversation is difficult, and if it is too quiet, unwanted conversations and other distracting noises will be heard.

Measuring NC takes a sound level meter with octave band analysis, which is acoustic consultant territory. What the facility team can do is notice and report new tones, rattles or hissing, and keep the maintenance that prevents them on schedule. Our HVAC maintenance guide covers that routine. Anything that needs rebalancing, new diffusers or vibration isolation goes to a mechanical contractor or acoustic consultant. MAFM does not do that work itself; it can schedule and coordinate it.

Does sound masking work, and what level is right?

Sound masking helps with speech privacy in open offices, when it is set at the right level and combined with other measures. It adds a low, even background sound so that distant conversation is less intelligible. GSA recommends specifying sound masking systems, particularly in open-plan areas.

The WELL Building Standard's sound masking feature gives the target range: 45 to 48 dBA in open workspaces and 40 to 42 dBA in enclosed offices, measured at the nearest workspace (WELL Standard, Sound masking). A system that is too loud or poorly tuned creates its own complaints, so have it installed and calibrated by a specialist and re-check the levels after any layout change.

Be realistic about what masking cannot do. GSA says that speech is unintelligible to casual listeners only when voices are low, background sound is continuously present and absorbent material surrounds the talker. A truly confidential conversation belongs in a fully enclosed room.

What operational fixes help the most?

Most of the effective measures cost little. These are the ones GSA's guide supports:

  • Absorb: GSA specifies ceilings with a noise reduction coefficient (NRC) of at least 0.9 in open-plan areas, and absorptive panels with an NRC of at least 0.8 on 25% of walls in conference and meeting rooms.
  • Zone: keep noise generators such as meeting areas, break rooms and printers away from people doing focused work, and cluster people who do similar work together.
  • Do not rely on distance or tall panels: GSA notes that doubling the distance only drops the sound level by about 5 decibels, which is barely perceptible. Higher cubicle partitions give little extra shielding and can encourage people to talk louder.
  • Choose doors with care: hinged doors typically seal better than sliding doors.
  • Set call norms: speak in a low voice, take long calls in enclosed rooms, do not use speakerphones in the open and look before you interrupt someone who is concentrating.
  • Give people a place to go: small focus rooms and quiet areas where a call or concentrated work can happen.

Conference rooms are a common source of spill, so the habits matter as much as the hardware. Our guide to conference room and shared space management covers booking and etiquette.

How do you plan acoustics when moving or reconfiguring an office?

Think about sound at the layout stage, because fixing it afterward costs more. When desks, meeting rooms and break areas move, the noise map moves with them. GSA's guide says integrated acoustic design should be considered at the beginning of the design process rather than "fixed" afterward.

During an office move or reconfiguration, ask where copiers, kitchens and conference room doors will end up relative to quiet work, and what the ceilings and walls will absorb. Office moves and changes are the right moment to fix a floor plan that was creating noise problems.

Frequently asked questions

What is the most common acoustic complaint in open offices?

Lack of sound privacy: people hearing others' conversations. In the Center for the Built Environment survey analysis, sound privacy had the highest dissatisfaction of any comfort factor in open-plan offices.

What background noise level should an office have?

The WBDG lists NC 35 to 40 for general offices and NC 30 to 35 for private offices and small conference rooms. A consultant can measure NC at your desks.

Is sound masking worth it?

It is a recognized tool for improving speech privacy in open offices. It works best as part of a plan that also adds absorption, zoning and call norms.

Can a facility manager fix acoustic problems without construction?

Often, yes. Changing where noisy activities sit, setting call norms, adding absorptive panels and keeping HVAC equipment in good order all improve conditions without building work.

Talk to MAFM about your floor plan

MAFM is a facilities management company in San Jose. We coordinate the building services, vendors and moves that shape how a workplace sounds, and we can plan an office change around the quiet zones your teams need. See our facility management service or contact MAFM to start with a walkthrough.

Ready to Optimize Your Facilities?

MAFM offers comprehensive facility management solutions tailored to your business needs.

Get in Touch